How to assembly bicycle wheels

(все про втулки, камери, ободи, покришки, спиці)
icarbonsports
новичок
новичок
Повідомлень: 1
З нами з: 24.2.12 08:40
Стать: чол

How to assembly bicycle wheels

Повідомлення icarbonsports » 17.5.19 04:47

1.Place rim on pre-assemble support tool ( if you are an individual user do not need this tool.
Зображення
2. Place hub on pre-assemble support tool.
Зображення
3.Put some grease on head of spoke.
Зображення
4.Insert the first 10 spokes (This is  20holes front hub) through upper hub holes.Remember to put some grease on each  spoke head.
Зображення
5.Insert an spoke from inside rim spoke hole to outside rim spoke hole.
Зображення
6. Thread a nipple on end side spoke.
Зображення
7.Place nipple on inside rim hole.
Зображення
8.Place nipple tool on outside hole to avoid loose nipple inside the rim.
Зображення
9.Remove the spoke used before.
Зображення
10.Place j-bend spoke on nipple.
Зображення
11.Repeat steps other spokes  1 by 1.
Зображення
12.Turn the Wheel and insert other spokes.
Зображення
13.Screw all nipples until you can see only 1 thread wire on each nipple.
Зображення
14.Prepare tools for truing and dishing process.
Зображення
15.Put front Wheel on truing stand, screw each nipple 1 by 1 (not skip any nipples). not more than ¼ turn each time.  Until you don't feel spokes loose.
Зображення
16.Adjust wheel flatness .tight or relase nipple 1 by 1 . When the rim is close to the left side, tight right nipple ( ¼ turn) and  release the left side nipple  ( ¼ turn) .(do not keep turn 1 nipple until the left and right distances are balanced. it will let you hard to made the rim's roundness) , the correct ways is check next one, after you check all nipple you will find the when is more flatness than before!
Зображення
17.Use the center arch tool to check the rim will be in center of hub.
Зображення
18.Get spoke tension according spokes and rim type. Follow rim manufacturer values. 
Зображення
19.Adjust wheel roundness,tight or release nipple   ( 1/8 turn) , 1 by 1 . you can check with dial gage  .standard < 20.
Зображення
20.To release stress tension on spokes due to truing process, proceed to bend with hands each two spokes. 
Зображення
21.Finally apply a force (60kg) on hub. First one side. Turn the Wheel and place again on bench Wheel support. Aplly again a force on the other hub side, and second the other side. 
Зображення

Повернутись до “Колеса”

Хто зараз онлайн

Зараз переглядають цей форум: Немає зареєстрованих користувачів і 2 гостей